Measuring and cutting out side panels

After a lot of reading up and visiting tons of cabinet building sites I eventually decided to settle on the Centipede cabinet design. See here for plans and a pic

I’ve also uploaded some close up shots of the Centipede arcade which I’m going to base my build on.

First thing was to measure out the side panels.

After double checking the measurements (The old saying still applies – measure twice,  cut once) its time to start cutting.  You will make you life a lot easier and save yourself a lot of trouble if you made use of clamps when you are working.

Finally finished cutting out both side panels:

Also cut the sides off the TV so it doesn’t make the width of the cabinet too wide.

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.